To set up and connect the GNSS receiver

To set up and connect your surveying equipment when using a Trimble integrated GNSS receiver:

  1. Assemble and erect the equipment.

    1. Set the antenna over the ground mark using a tripod, a tribrach, and a tribrach adaptor.

    2. Use the tripod clip to hang the receiver on the tripod.

      Alternatively, place the receiver in its base case. Run the antenna cable out of the portal in the side of the base case to the antenna so that the case can stay closed while the receiver is running.

    3. Assemble and erect the radio antenna.

    1. Mount the receiver onto a range pole. Power for the receiver is supplied by the internal battery in the receiver.

      In a postprocessed survey you may find it useful to use a bipod to hold the range pole while taking measurements.

    2. Attach the controller to the holder.
    3. Connect the controller holder to the range pole.
  2. Connect the controller and the receiver using the appropriate cable to Bluetooth. See Bluetooth connections.
  3. If you are using an RTK radio survey, connect the controller, receiver, radio and, if required, the power supply. See To connect a radio to the GNSS receiver.

  4. Turn on the receiver.

  5. Turn on the controller.

  6. If you are using an RTK Internet or dial-in survey, connect the controller, receiver and, if required, the external device:

    1. If the modem is an external device such as a cellular phone, turn on the device and connect it to the controller using Bluetooth or a serial cable.

    2. Connect the receiver to the controller using Bluetooth or a serial cable.

      If you are using an RTK dial-in survey, make sure you connect the equipment using the method configured in the survey style. See To configure a rover dial‑in data link.

      To connect the controller to the receiver using Bluetooth:

      1. Tap and select Settings / Connections / Bluetooth.
      2. In the Connect to GNSS rover field, select the receiver.
      3. Pair with the device.

      For more information, see Bluetooth connections.

  7. On the controller, start Trimble Access. If the Trimble Access software does not automatically connect to the receiver, see Auto‑connect options.