To stake out a DTM

For information on supported DTMs, see DTMs and surfaces.

1. Tap Stakeout / DTMs.

2. Select the file to be used.

   All DTM files in the current project folder are listed.

3. If required, in the Offset to DTM field, specify an offset to the DTM. Tap and select whether the offset is to be applied vertical or perpendicular to the DTM. The V.Dist DTM value is to the offset position.
4. To change the target or antenna height, tap the target or antenna icon in the status bar.

   If the target or antenna height have not been defined, the elevation and cut/fill will be null (?).

5. Tap Start.

   The coordinates of the current position and the distance above (cut) or below (fill) the DTM are shown.

   Unless you are using a conventional instrument that supports tracking, the values appear only after you have taken a distance measurement.

6. When the point is within tolerance, tap Measure to measure the point.

   When using a Trimble SX12 scanning total station in TRK mode with the laser pointer enabled, the Stakeout screen shows the Mark point softkey instead of the Measure softkey. Tap Mark point to put the instrument into STD mode. The laser pointer stops flashing and moves to position itself at the EDM location. When you tap Accept to store the point, the instrument automatically returns to TRK mode and the laser pointer resumes flashing. To remeasure and update the stakeout deltas, tap Measure after you tap Mark point and before you tap Accept. For more information, see EDM settings.

7. Tap Accept to store the point.
8. If you selected the View before storage option, the staked deltas you selected in the Stakeout options screen are shown. Tap Store.

When staking out the DTM, if you are outside the extent of the DTM or in a "hole", the DTM elevation and cut/fill will be null (?).