2022.11
Version 2022.11 of the Trimble Access software is available from December 2022.
These Release Notes describe the new features and changes available in this release of the
Resolved issues
- Georeference map: We have fixed an issue where the Georeference map function did not appear in the Cogo menu if you were using Trimble Access with a GNSS-only license.
- Rotated JPG files: We have fixed an issue where rotated JPG files were not drawn using the correct rotation and scale if the job units were set to feet.
- Finger mode on T100: We have fixed an issue where if the Trimble T100 tablet was configured to use Finger mode then when you attempted to tap and hold in Trimble Access (for example in the map), then the tap and hold menu did not appear. This issue did not occur if the T100 was configured to use Stylus mode or Tablet mode.
- SX12 Wi-Fi connection: We have fixed an issue where you would occasionally be incorrectly prompted for a password when connecting to a Trimble SX12 scanning total station over Wi-Fi.
- GNSmart VRS connections: We have resolved an issue that prevented Trimble Access from working reliably with a Geo++ GNSmart network.
- Upgrading jobs using NAD83: In Trimble Access 2022.10 we renamed United States/State Plane 1983 zones to United States/NAD83 to clarify that these zones were based on the NAD83 datum. This rename had the unintended consequence that if you upgraded jobs from earlier versions then the coordinate system was displayed as Local site. Upgrading jobs created with earlier versions of Trimble Access now correctly renames the coordinate system zone.
- Application errors: We have fixed several issues that caused occasional application errors when using or closing the software. In particular:
Using binary DXF files (rather than ASCII DXF files) on an Android controller would cause Trimble Access to close unexpectedly.
